Mercury XR2 Manual de instalación descargar pdf (Pagina 14)

- 14 -

6. Install shift cable end in slot of the reverse gate

and secure with clevis pin, flat washer, and cotter

pin. Bend over ends of cotter pin.

a - Clevis Pin

b - Flat Washer

c - Cotter Pin

WARNING

The shift cable must be adjusted correctly so that

the reverse gate does not interfere with water flow

coming out of the rudder. If the reverse gate

hangs down into the water flow, a vibration may

be felt in the control box. If this occurs, reduce

throttle immediately and readjust the cable. Im-

proper adjustment may result in pump damage

including loss of the reverse gate. Failure to prop-

erly adjust the shift cable could result in loss of

neutral and reverse, property damage, personal

injury or death.

7. Adjust shift cable as follows:

a. Position the control box into forward position.

b. Position the bottom edge of the reverse gate

9.5 to 12.7 mm (3/8 - 1/2 in.) above the rudder.

With the reverse gate at this position, adjust

the cable barrel to fit into the barrel holder.

c. After adjusting the shift cable, secure the

cable barrel in place with the shift cable retain-

er. Fasten the retainer by tightening both lock-

nuts.

IMPORTANT: The shift cable retainer must be fas-

tened with self-locking nylon insert locknuts.

These locknuts must never be replaced with com-

mon nuts (non-locking) as they could vibrate off,

freeing the shift cable to disengage.

WARNING

Disengagement of the shift cable can result in the

boat suddenly shifting into reverse. This unex-

pected action could cause occupants to be

thrown forward in the boat or to be ejected over-

board. Serious injury or death could result.

9.5 – 12.7 mm (3/8 in. – 1/2 in.)

a - Cable Barrel

b - Locknuts

c - Shift Cable Retainer

8. Adjust the reverse stop (located on starboard side

of the nozzle) so that the stop just touches the re-

verse gate with the control handle in reverse posi-

tion. Torque reverse stop screw to 14 Nm (120 lb

in.).

9. Check shift cable/reverse gate adjustment as fol-

lows:

a. Shift the control box a few times from the for-

ward position to reverse position.

b. Return the control handle back to forward and

check for the 9.5 to 12.7 mm (3/8 to 1/2 in.)

clearance space between the reverse gate

and rudder. If necessary, readjust the cable

barrel.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 20 21

Comentarios a estos manuales

Sin comentarios

Mercury XR2 Manual de instalación Pagina 14

Comentarios a estos manuales

Relacionado con productos y manuales para Motor Mercury XR2