Mercury XR2 Manual de instalación descargar pdf (Pagina 17)

- 17 -

6. Secure powerhead to drive housing cover with

eight (8) M10 x1.5 nuts. Torque fasteners to 47

Nm (35 lb ft) following the torque sequence given.

Repeat torque sequence to ensure all fasteners

retain their torque.

TOP VIEW





28242

28237

a - M10 x 1.5 Nuts – Torque to 47 Nm (35 lb ft)

7. Connect fuel line to fuel inlet fitting, secure with

U.S. Coast Guard approved hose clamp

(183.532).

55087

b - Fuel Inlet Fitting

Battery Connection

NOTE: Engine electrical system is negative (–)

ground.

1. Connect positive (+) battery cable (usually red) to

starter solenoid using protective boot (provided).

2. Connect negative (–) battery cable (usually black)

to engine ground at forward starter motor bolt.

WARNING

U.S. Coast Guard regulation #33 CFR 183.445 re-

quires that the positive battery cable connection

at the starter solenoid terminal be protected by ei-

ther a boot (“b” shown following), or protective

shield.

28238

a - Positive Battery Cable Attaching Location

b - Boot Protector for Positive Battery Cable

28237

c - Forward Starter Bolt (Engine Ground)

3. Connect battery cables to battery. Make sure that

all battery terminal connections are tight; then,

spray terminals with a battery connection sealant

to help prevent corrosion.

1 2 ... 12 13 14 15 16 17 18 19 20 21

Sin comentarios

Mercury XR2 Manual de instalación Pagina 17