Mercury 200 Optimax Manual de instalación descargar pdf (Pagina 12)

200/225/250 OPTIMAX

Page 12 of 38

Fuel Hose Connection

Fuel Hose Size – Minimum fuel line inside diameter (I.D.) is 5/16 in. (8mm), with separate

fuel line/fuel tank pickup for each engine.

Fasten remote fuel hose to fitting with hose clamp.

Oil Hose Connections

Connect the remote oil hoses to the engine hose connections as shown. Fasten hose con-

nections with sta-straps.

Speedometer Tubing Connection (Models without SmartCraft Speedometer)

This outboard has a speedometer water pick-up located in the leading edge of the gear

case. If you want to use this water pickup for the speedometer, disconnect the water pickup

tubing from the speedometer sensor and route tubing out of the cowl. Install coupler (pro-

vided with outboard) on end of tubing.

Water Pressure Tubing Connection (Models without SmartCraft Water PSI Gauge)

Make the water pressure gauge hose connection to this tubing as shown.

a-Remote Fuel Hose

b-Hose Clamp – Secure Remote Fuel Hose

c-Oil Hoses with Blue Stripe - Secure With Sta-Strap

d-Oil Hoses without Blue Stripe - Secure With Sta-Strap

e-Sta-Strap (2) - Secure Oil Hoses

f-Speedometer Water Pickup Tubing (Black Color)

g-Water Pressure Tubing (Gray Color)

h-Coupler (859747) – Push In on End of Coupler to Disconnect Plug or Tubing

i-Plug (if equipped) – Remove when Making Coupler Connection

j-Barb Hose Fitting (2) (859731) Provided with Outboard – Install this fitting into

Coupler, if a Rubber Hose Connection is Required

k-Speedometer Hose – Insert the barb hose fitting (j) into Coupler and Connect

Hose

l-Water Pressure Tube – Insert into Coupler, Pull on Tube to Verify That it is

Locked

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 37 38

Sin comentarios

Mercury 200 Optimax Manual de instalación Pagina 12