Mercury 200 Optimax Manual de instalación descargar pdf (Pagina 5)

200/225/250 OPTIMAX

Page 5 of 38

Steering Link Rod

1. Install steering link rod per illustration.

a-Special Bolt (10-849838) Torque to 20 lb. ft. (27 N·m)

b-Nylon Insert Locknut (11-34863) Torque to 20 lb. ft. (27 N·m)

c-Flat Washer (2)

d-Nylon Insert Locknut (11-34863) Tighten Locknut Until it Seats, Then Back Nut

Off 1/4 Turn

IMPORTANT: The steering link rod that connects the steering cable to the engine

must be fastened using special bolt (“a” - Part Number 10-849838) and self locking

nuts (“b” & “c” - Part Number 11-34863). These locknuts must never be replaced with

common nuts (non locking) as they will work loose and vibrate off, freeing the link

rod to disengage.

WARNING

Disengagement of a steering link rod can result in the boat taking a full, sudden,

sharp turn. This potentially violent action can cause occupants to be thrown over-

board exposing them to serious injury or death.

1 2 3 4 5 6 7 8 9 10 ... 37 38

Sin comentarios

Mercury 200 Optimax Manual de instalación Pagina 5