Mercury 200 Optimax Manual de instalación descargar pdf (Pagina 25)

200/225/250 OPTIMAX

Page 25 of 38

Paddle Wheel Speed Sensor Installation (If Equipped)

ROUTING THE CABLE

NOTE: You can choose to drill a hole through the transom for routing the cable, or you can

route the cable over the transom or through a drain hole above the water line.

If you choose to drill a hole through the transom, follow these instructions:

1. Select a transom location

for the hole above the water line

that does not interfere with

other cables and controls.

2. Drill a 5/8 in. (15 mm) diameter Hole.

3. Route the cable through the drilled hole. Seal the transom hole with silicone (RTV) or

a comparable marine sealant after you routed the cable through.

NOTE: The hole for the first clamp should be l in. (25 mm) above the paddle wheel. The hole

for the second clamp should be positioned halfway between the first clamp and the cap cov-

ering the transom hole you drilled for the cable.

4. Using a 7/64 in. (2.8 mm) bit, drill holes for the clamps and cap approximately 1/2 in.

(13 mm) deep.

5. Apply silicone (RTV) or a comparable marine sealant to the screw threads and Install

the cable clamps and the cable feed-thru cap.

If you choose not to drill a hole through the transom:

If you prefer not to drill a hole, route the cable over the transom or through a drain hole that

is above the water line.

1 in.

(25.4 mm)

a-The First Clamp Should be Placed 1 in. (25 mm) Above the Paddle Wheel

b-The Second Clamp Should be Positioned Halfway Between the First Clamp and

the Cable Cap

c-Cable Cap

d-If You Prefer Not to Drill A Hole, Route the Cable Over the Transom or Through

a Drain Hole

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 37 38

Sin comentarios

Mercury 200 Optimax Manual de instalación Pagina 25