Mercury 200 Optimax Especificaciones descargar pdf (Pagina 117)

OPERATION

eng 105

b. Turn the ignition key switch to the "ON" position for three

seconds. This operates the electric fuel pump.

c. Turn the ignition key switch back to the "OFF" position,

and squeeze the primer bulb again until it feels firm. Turn

the ignition key switch to the "ON" position again for three

seconds. Continue this procedure until the fuel line primer

bulb stays firm.

7. Ignition key starting ‑ Turn the ignition key to "START"

position and release the key. The electronic starting system

will automatically crank the engine for starting. If the engine

fails to start, the engine will stop cranking. Turn the key to

"START" position again until engine starts.

3485

8. After the engine starts, check for a steady stream of water

flowing out of the water pump indicator hole.

19805

IMPORTANT: If no water is coming out of the water pump

indicator hole, stop engine and check the cooling water intake

for obstruction. No obstruction may indicate a water pump

failure or blockage in the cooling system. These conditions will

cause the engine to overheat. Have the outboard checked by

your dealer. Operating the engine while overheated will cause

engine damage.

1 2 ... 112 113 114 115 116 117 118 119 120 121 122 ... 156 157

Sin comentarios

Mercury 200 Optimax Especificaciones Pagina 117