Mercury 200 Optimax Especificaciones descargar pdf (Pagina 130)

MAINTENANCE

118 eng

Fuse Replacement

IMPORTANT: Always carry spare 2, 5 and 20 amp fuses.

The electrical wiring circuits on the outboard are protected from

overload by fuses in the wiring. If a fuse is blown, try to locate

and correct the cause of the overload. If the cause is not found,

the fuse may blow again.

Open the fuse holder and look at the silver colored band inside

the fuse. If band is broken, replace the fuse. Replace fuse with a

new fuse with the same rating.

a - Good fuse

b - Blown fuse

c - Power on circuit ‑ 20 amp fuse

d - Ignition system circuit ‑ 20 amp fuse

e - Spare fuse slot

f - Fuel injector/direct injector/starter slave solenoid/PCM and

electric fuel pumps circuit ‑ 20 amp fuse

g - Diagnostic circuit ‑ 2 amp fuse

h - DTS power harness circuit (fuse holder located near

starting battery) ‑ 5 amp fuse

28784

1 2 ... 125 126 127 128 129 130 131 132 133 134 135 ... 156 157

Sin comentarios

Mercury 200 Optimax Especificaciones Pagina 130