Mercury 200 Optimax Especificaciones descargar pdf (Pagina 131)

MAINTENANCE

eng 119

DTS Wiring System

WARNING

Splicing or probing will damage the wire insulation allowing

water to enter the wiring. Water intrusion may lead to wiring

failure and loss of throttle and shift control. To avoid the

possibility of serious injury or death from loss of boat control,

do not splice or probe into any wire insulation of the DTS

system.

• Verify the harnesses are not routed near sharp edges, hot

surfaces, or moving parts.

• Verify all unused connectors and receptacles are covered

with a weather cap.

• Verify the harnesses are fastened along the routing path.

Corrosion Control Anode

Your outboard has corrosion control anodes at different

locations. An anode helps protect the outboard against galvanic

corrosion by sacrificing its metal to be slowly corroded instead of

the outboard metals.

Each anode requires periodic inspection, especially in saltwater

which will accelerate the erosion. To maintain this corrosion

protection, always replace the anode before it is completely

eroded. Never paint or apply a protective coating on the anode,

as this will reduce effectiveness of the anode.

1 2 ... 126 127 128 129 130 131 132 133 134 135 136 ... 156 157

Sin comentarios

Mercury 200 Optimax Especificaciones Pagina 131