Mercury 200 Optimax Especificaciones descargar pdf (Pagina 130)

OUTBOARD INSTALLATION

118 eng

Use a dial torque wrench to determine transom strength. If the

bolt or nut continues to turn without the torque reading on the

dial increasing, it is an indication the transom is yielding. The

load area can be increased by using a larger washer or a

transom reinforcement plate.

a - Large transom washer

b - Transom reinforcement plate

1. Apply marine sealer to the shanks of the bolts, not to the

threads.

2. Fasten the outboard with the correct mounting hardware.

Tighten the locknuts to the specified torque.

IMPORTANT: Ensure a minimum of two full threads of the

mounting bolts extend beyond the locknut after tightening. The

locknut must be drawn tight while still engaging the bolt threads

and not contacting the shank of the bolt.

33962

1 2 ... 125 126 127 128 129 130 131 132 133 134 135 ... 148 149

Sin comentarios

Mercury 200 Optimax Especificaciones Pagina 130