Mercury 200 Optimax Especificaciones descargar pdf (Pagina 92)

MAINTENANCE

80 eng

The electrical wiring circuits on the outboard are protected from

overload by fuses in the wiring. If a fuse is blown, try to locate

and correct the cause of the overload. If the cause is not found,

the fuse may blow again.

Open the fuse holder and look at the silver colored band inside

the fuse. If the band is broken, replace the fuse with a new fuse

of the same rating.

a - SmartCraft data bus circuit ‑ 5 amp fuse

b - Accessories ‑ 20 amp fuse

c - Ignition coil circuit ‑ 20 amp fuse

d - Electric fuel pump/ECM driver power/oil pump circuit ‑

SFE 20 amp fuse

Corrosion Control Anode

Your outboard has corrosion control anodes at different

locations. An anode helps protect the outboard against galvanic

corrosion by sacrificing its metal to be slowly corroded instead of

the outboard metals.

Each anode requires periodic inspection, especially in saltwater

which will accelerate the erosion. To maintain this corrosion

protection, always replace the anode before it is completely

eroded. Never paint or apply a protective coating on the anode,

as this will reduce effectiveness of the anode.

2917

20 20

1 2 ... 87 88 89 90 91 92 93 94 95 96 97 ... 148 149

Sin comentarios

Mercury 200 Optimax Especificaciones Pagina 92