Mercury D2.8L D-Tronic Especificaciones Pagina 134

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 160
  • Tabla de contenidos
  • SOLUCIÓN DE PROBLEMAS
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 133
STORAGE
SECTION 6
Page 126 CMD-4081850 / 90-860094030 SEPTEMBER 2003
0084 w / CMD
Cold Weather Or Extended Storage
IMPORTANT: Cummins MerCruiser Diesel strongly recommends that this service
should be performed by an authorized Cummins MerCruiser Diesel dealer / distribu-
tor. Damage caused by freezing IS NOT
covered by the Mercury MerCruiser Limited
Warranty.
CAUTION
Seawater section of cooling system MUST BE COMPLETELY drained for winter
storage, or immediately after cold weather use, if the possibility of freezing
temperatures exist. Failure to comply may result in trapped water causing freeze
and/or corrosion damage to engine. Damage caused by freezing is NOT covered by
the Mercury MerCruiser Limited Warranty.
IMPORTANT: Cummins MerCruiser Diesel recommends that propylene glycol anti-
freeze (a nontoxic and environmentally safe) antifreeze be used in the seawater sec-
tion of the cooling system for cold weather or extended storage. Make sure that the
propylene glycol antifreeze contains a rust inhibitor and is recommended for use in
marine engines. Be certain to follow the propylene glycol manufacturer’s recommen-
dations.
0085 w / changes, used diesel information here
Preparing Your Power Package For Storage
CAUTION
The engine must be prepared for long storage periods to prevent internal corrosion
and severe damage.
IMPORTANT: If boat has already been removed from water, before starting engine a
source of water must be supplied to water intake (inlet) openings. Follow all warnings
and flushing attachment procedures stated in “FLUSHING COOLING SYSTEM”.
CAUTION
Do not operate engine without water flowing thru seawater pickup pump, as pump
impeller may be damaged and subsequent overheating damage to engine or drive
unit may result.
1. Start the engine and operate until it reaches normal operating temperature.
2. Stop the engine. Change the oil and filter.
3. Start the engine and run for about 15 minutes. Check for oil leaks.
4. Flush the seawater cooling system. Refer to SECTION 5 - Flushing The Seawater
System.
Vista de pagina 133
1 2 ... 129 130 131 132 133 134 135 136 137 138 139 ... 159 160

Comentarios a estos manuales

Sin comentarios