Mercury D2.8L D-Tronic Especificaciones descargar pdf (Pagina 143)

STORAGE

SECTION 6

CMD-4081850 / 90-860094030 SEPTEMBER 2003 Page 135

2. Ensure that all cooling system hoses are in good condition, connected properly, and

hose clamps are tight. Verify that all drain valves and drain plugs are installed and tight.

3. Inspect all drive belts.

4. Perform all lubrication and maintenance specified for completion Annually in

Maintenance Schedule, except items that were performed at time of engine layup.

5. Fill fuel tanks with fresh diesel fuel. Old fuel should not be used. Check fuel lines and

connections for leaks and general condition.

6. Replace fuel filter

7. For drive unit, refer to appropriate Mercury MerCruiser Sterndrive Service Manual.

CAUTION

When installing battery, connect POSITIVE (+) battery cable to POSITIVE (+) battery

terminal FIRST, and NEGATIVE (–) battery cable to NEGATIVE (–) battery terminal

LAST. If battery cables are reversed, or connection order is reversed, electrical

system damage will result.

8. Install a fully charged battery. Clean the battery cable clamps and terminals. Reconnect

the cables (see CAUTION listed above). Secure each cable clamp when connecting.

Coat terminals with a battery terminal anti-corrosion spray to help retard corrosion.

9. Perform all checks on OPERATION CHART in the STARTING PROCEDURE column

found in the Operation, Maintenance and Warranty Manual provided with the product.

CAUTION

Overheating from insufficient cooling water will cause engine and drive system

damage. Ensure that there is sufficient water always available at water inlet holes

during operation.

10. Supply cooling water to the water inlet openings.

IMPORTANT: On all models except EDI (D-Tronic) models: After not having been op-

erated for two months or longer, it is necessary to pre-lubricate the engine and turbo-

charger. To do this, hold the STOP switch engaged while you simultaneously turn the

key switch to START position for 15 seconds. This will rotate the starter motor and

engine/oil pump. During this process the engine will not run because no fuel is in-

jected. Allow the starter motor to cool down for one minute and repeat the above de-

scribed process. To avoid overheating the starter motor, do not engage starter motor

for more than 15 seconds each time.

11. On all models except EDI (D-Tronic) models: Pre-lubricate the engine and

turbocharger, if necessary. Refer to above Important information.

12. Start the engine and closely observe instrumentation. Ensure that all systems are

functioning correctly.

13. Carefully inspect the engine for fuel, oil, fluid, water and exhaust leaks.

14. Check the steering system, shift and throttle control for proper operation.

1 2 ... 138 139 140 141 142 143 144 145 146 147 148 ... 159 160

Sin comentarios

Mercury D2.8L D-Tronic Especificaciones Pagina 143