
GETTING TO KNOW YOUR POWER PACKAGE
SECTION 2
Page 16 CMD-4081850 / 90-860094030 SEPTEMBER 2003
00000 was CE479 and CD860
ENGINE MONITORING FEATURES
77359
a b c d e
n
f
a-Malfunction indicator lamp (D-Tronic engines)
b-Water-in-fuel warning lamp
c-Coolant temperature warning lamp
d-Oil pressure warning lamp
e-Charge indicator lamp
f-Preheat indicator lamp
The appropriate light functions as follows:
Malfunction Indicator Lamp (MIL), D2.8L D-Tronic, D4.2L D-Tronic and D4.2L 300 Only
- additional lamp indicates when a problem exists, or a malfunction has occurred, that
requires service.
Water-In-Fuel Warning Lamp - indicates water is present in fuel filter and that fuel filter
requires service.
Coolant Temperature Warning Lamp - indicates excessive engine coolant temperature
if lamp illuminates while engine is running.
Oil Pressure Warning Lamp - indicates low engine oil pressure if lamp illuminates while
engine is running, or low oil level in the gear lube monitor bottle. (See the following note).
NOTE: The oil pressure warning lamp is wired in a parallel circuit with the gear lube monitor
bottle switch. If lamp illuminates while engine is running and oil pressure and oil level are
normal, this may be an indication of low oil level in the gear lube monitor bottle. The cause
should be determined and corrected.
Charge Indicator Lamp - indicates a problem with charging system if lamp illuminates
while engine is operating. Lamp will be on when key switch is in RUN and engine is not
operating. When engine starts, light should go off.
Preheat Indicator Lamp - indicates when the glow plugs, if equipped, are preheating the
combustion chambers. When the engine is cold the timed preheat period begins when the
key switch is turned to RUN. The light stays on until the preheat period is complete. The
engine can be started only after the light goes out.
Comentarios a estos manuales