Mercury D2.8L D-Tronic Especificaciones Pagina 87

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 160
  • Tabla de contenidos
  • SOLUCIÓN DE PROBLEMAS
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 86
MAINTENANCE
SECTION 5
CMD-4081850 / 90-860094030 SEPTEMBER 2003 Page 79
6. Remove and discard oil filter and sealing ring.
7. Coat sealing ring on new filter with oil and install filter. Hand tighten only, do not use a
filter wrench.
a
74725
Typical engine and oil filter, all similar
a-Oil filter
8. Remove oil fill cap and refill engine with new oil. Refer to Filling.
IMPORTANT: When refilling engine with oil always use dipstick to determine how
much oil is required.
IMPORTANT: On all engines except EDI (D-Tronic) models: After oil change, pre-lubri-
cate turbocharger and engine. To do this, engage the stop switch and hold while you
turn the key switch to START position. Doing this TOGETHER turns the engine with-
out starting it. Do not engage starter for more than 15 seconds; allow at least one min-
ute cool down time before re-engaging starter for another 15 seconds. Ensure that
the starter does not overheat.
9. Start the engine and check for leaks.
Vista de pagina 86
1 2 ... 82 83 84 85 86 87 88 89 90 91 92 ... 159 160

Comentarios a estos manuales

Sin comentarios