Mercury ALPHA Especificaciones descargar pdf (Pagina 133)

131

D Install new anode. Tighten screws securely.

E Reinstall propeller. See Propeller Installation for proper tighten-

ing.

8 Bearing Carrier Anode - is located in front of the propeller,

between the front side of the propeller and the gear housing. Refer

to Propeller section in this manual for propeller removal and

installation.

9 Gear Housing Anode (Bravo Two and Three) - is located in the

splash plate, just above the propellers.

CA965

In addition to the corrosion protection devices, the following steps

should be taken to inhibit corrosion:

IMPORTANT: Corrosion damage that results from the improper

application of anti-fouling paint will not be covered by the

limited warranty.

1 Painting Boat Hull or Boat Transom: Anti-fouling paint may be

applied to boat hull and boat transom

but you must observe the

following precautions:

IMPORTANT: DO NOT paint anodes or MerCathode System

reference electrode and anode, as this will render them

ineffective as galvanic corrosion inhibitors.

IMPORTANT: If anti-fouling protection is required for boat hull

or boat transom, copper or tin base paints, if not prohibited by

law, can be used. If using copper or tin based anti-fouling

paints, observe the following:

INDEX

1 2 ... 128 129 130 131 132 133 134 135 136 137 138 ... 180 181

Sin comentarios

Mercury ALPHA Especificaciones Pagina 133