Mercury ALPHA Especificaciones descargar pdf (Pagina 99)

CA967

Changing Drive Unit Oil

1 Remove gear lube monitor bottle from bracket.

2 Empty contents into suitable container.

3 Install monitor in bracket.

4 Bravo One Models: Remove propeller, place drive unit in full trim

limit IN position, remove OIL FILL/DRAIN SCREW and sealing

washer, and drain oil.

5 All Other Models: Place drive unit in full trim limit OUT position,

remove OIL FILL/DRAIN SCREW and sealing washer, and drain oil.

6 Remove OIL VENT screw and sealing washer. Allow oil to drain

completely.

IMPORTANT: If any water drained from OIL FILL/DRAIN hole, or

if oil appears milky, drive unit is leaking and should be checked

immediately by your Authorized Mercury MerCruiser Dealer.

7 Lower drive unit so propeller shaft is level. Fill drive unit, through

OIL FILL/DRAIN hole, with specified gear lube until an air-free

stream of lubricant flows from OIL VENT hole.

IMPORTANT: Use only Quicksilver High Performance Gear

Lube in drive unit.

8 Install OIL VENT screw and sealing washer.

9 Continue to pump gear lube into the gear lube monitor circuit until

gear lube appears in the gear lube monitor.

10Fill monitor to FILL mark. Ensure that rubber gasket is inside cap.

Install cap; DO NOT overtighten.

11 Remove pump from OIL FILL/DRAIN hole. Quickly install sealing

washer and OIL FILL/DRAIN screw. Tighten securely.

12Bravo One and Alpha Models: Grease propeller shaft heavily,

with specified lubricant (Refer to Propeller Installation). Reinstall

propeller and torque nut to 55 lb-ft (75 Nm) MINIMUM.

13Recheck oil level after first use.

IMPORTANT: Oil level in gear lube monitor will rise and fall

during drive operation; always check oil level when drive is cool

and engine is shut down.

INDEX

1 2 ... 94 95 96 97 98 99 100 101 102 103 104 ... 180 181

Sin comentarios

Mercury ALPHA Especificaciones Pagina 99